How to install the Tape

THE EASIEST AND SIMPLEST WAY TO INSTALL HORSEGUARDFRENCH  FENCE FROM THE BUCKLE #1 TO THE BUCKLE #2

Install one mile of HorseGuard Tape in less than 30 minutes !

Start installing all the insulators and the tensioners on the posts

1/ Attach the tape to the buckle of the first tensioner 36W (or 36M)
Make a loop with the tape.
Push it through the buckle.
Insert the tang in the loop		 Pull the end of the tape
To lock it, go again through the stainless steel buckle Secure the tail with the clip : (the clip is located between the cap and the base of the tensioner.)

Unrolling the spool of tape:

Unrolling the spool of tape:

Unroll the tape to
the next tensioner #36W

Pull the WHOLE tape by hand
(even a mile of tape is easy to pull)
2/ Unroll the spool of tape up to the second tensioner 36W.
Pull it hard and attach it to the buckle
Set the tape
in the #36W buckle.
Pull and set the final tension of your fence from one tensioner #36W to the next #36W.
Cut the tape 8″
from the buckle
Secure the tail
with the clip

 

Step 3 : How to secure the tape into the new #8 insulators

 


1- Once it has been attached onto the post which can be wood, pipe, fiberglass or Tpost.
2- Position the tape on it.

3- Close the cap and screw in the bottom #8 peg.
4- Then firmly screw in the other #8 peg but do not over tighten.